High-Touch Surface Cleaning in Offices During Flu Season
Flu season puts shared handles, buttons and fixtures in the spotlight. Here is how facility managers can separate routine cleaning from disinfecting, using CDC guidance.

Why High-Touch Surfaces Get Their Own Plan
Every office has a handful of places that nearly everyone touches: the main door, the elevator buttons, the stair rail, the break room faucet. When colds and flu move through the Twin Cities each fall, those spots draw the questions. Should they be cleaned more often? Do they need disinfecting? What goes in the instructions to the cleaning team?
This guide is for facility and office managers who want a clear answer to those questions. It follows the CDC's guidance for community buildings such as offices, and it separates two jobs that often get blurred together: routine cleaning of high-touch surfaces, and disinfecting when conditions call for it. Along the way it covers label rules, hand hygiene and staff training, so your office high touch surface cleaning plan for flu season rests on something you can point to.
What Counts as High-Touch in an Office
High-touch surfaces are the ones many different hands contact through the day. The CDC's facility guidance names door handles, counters, stair rails, elevator buttons and restroom fixtures as examples. Treat that list as a starting point, not an inventory of your building.
Entry points, hallways and elevators
Start where people arrive. Entry door handles, push plates, elevator call buttons and stair rails see traffic from employees, visitors and delivery staff alike. These are usually the first surfaces on a flu-season checklist because they are touched by people who share nothing else.
Shared work areas
Counters, break room fixtures and restroom faucets, flush handles and door pulls come next. Beyond the CDC's examples, walk your own floor plan and note anything shared: a copier panel, a conference room table, a shared phone or keyboard. Which of those belong on the list is a judgment about your building, not a rule, so write the list down and keep it with the cleaning scope.
Cleaning First, Disinfecting Second
The CDC's guidance is plain on the order of operations. Cleaning with soap or detergent removes most harmful germs from surfaces, and surfaces should be cleaned before they are sanitized or disinfected, because dirt can keep chemicals from working. If you want the full picture of how the three terms differ, our guide to cleaning, sanitizing and disinfecting walks through each one.
For routine upkeep, the CDC says to clean high-touch surfaces regularly and other surfaces when they are visibly dirty. It does not set a fixed schedule such as once a day or once an hour. Frequency depends on the type of surface and how often it is touched, and in high-traffic areas you may clean more often or disinfect in addition to cleaning.
In practice, that means a managed list rather than a single number. A shared restroom fixture in a busy suite may need attention more often than a private office door handle. Your cleaning provider should be able to tell you which surfaces are on the list, how often each one is addressed, and who checks that it happened.
When to Step Up to Disinfecting
Disinfecting is an added step, not the default. The CDC says to disinfect surfaces where people have obviously been ill, and it notes that during certain outbreaks, local health authorities may recommend specific disinfection procedures. If your county or the state health department issues guidance, that guidance sits above any general office policy.
Before disinfecting, the CDC advises increasing air circulation by opening doors and windows and using fans or HVAC settings. Build that into the procedure. The people applying the product are the ones closest to it.
Some offices choose to add disinfecting of the busiest surfaces during flu season as a policy decision. That works, as long as it is a deliberate choice written into the scope, not an assumption that more chemical means more protection.
Label Rules That Matter
Most disinfecting mistakes come from ignoring the label. The CDC's guidance points to a short list of rules:
- Use an EPA-registered disinfectant suited to the germ in question, because not all disinfectants work on all germs.
- Check that the label allows use on the surface you are treating.
- Keep the surface wet for the entire contact time listed on the label or Safety Data Sheet.
- Do not mix products.
- Wash hands with soap and water for 20 seconds afterward.
Contact time is easy to skip. A quick wipe-and-dry looks tidy, but if the surface dries before the listed time has passed, the label's conditions have not been met.
The CDC also says fogging, fumigation and electrostatic spraying are not recommended as primary disinfection methods unless the product label permits them. If a vendor pitches fogging as a flu-season upgrade, ask where on the label it is allowed. Our list of questions to ask your janitorial provider about chemicals is a good place to start that conversation.
Hand Hygiene Belongs in the Plan
Surface work is only part of the routine. The CDC's respiratory virus guidance pairs cleaning frequently touched surfaces with hand hygiene: handwashing with soap removes germs from hands, and when soap and water are not available, a hand sanitizer with at least 60 percent alcohol is the alternative. It also suggests that organizations place hand sanitizer dispensers near frequently touched surfaces.
For an office, that can be as simple as a dispenser by the main entrance and one near the elevator. It adds little cost and gives people a way to act between cleaning visits.
Training and Safety for the Cleaning Team
Disinfectants are chemicals, and the people who use them need to be trained before they are assigned the work. The CDC says to set policies and train workers first, including how to select, put on, use, remove and dispose of personal protective equipment as specified in the Safety Data Sheet. It also calls for adequate ventilation, labeled hazardous products and Safety Data Sheets that workers can reach.
Employers are expected to follow applicable OSHA standards, including the hazard communication standard (29 CFR 1910.1200) and the personal protective equipment standards (29 CFR 1910 Subpart I). If your cleaning is contracted, ask your provider how they handle training and Safety Data Sheet access in your building, and ask to see the answer in writing.
Setting Frequency for Your Floor Plan
Because the CDC leaves frequency open, your schedule should reflect how your space is used. An office with staff in five days a week has different needs than one running a hybrid week, and our piece on adjusting cleaning frequency for hybrid schedules shows how to match visits to actual occupancy. Whatever you choose, put the high-touch list, the frequency and the disinfecting triggers in the scope of work so everyone is working from the same page.
The Bottom Line
Clean high-touch surfaces regularly, disinfect on purpose, and follow the label every time. That is the core of the CDC's guidance for offices, and it leaves room for you to set the details based on traffic, occupancy and local health advice. If you are weighing how to cover this in a janitorial scope for a Twin Cities or North Metro building, browse our commercial cleaning service areas or request an estimate and we will talk through your facility.
Frequently Asked Questions
How often should high-touch surfaces in an office be cleaned?
CDC says to clean high-touch surfaces regularly and gives no fixed frequency. Busy areas such as shared restrooms and elevator buttons may need more passes than a private office.
Does an office need to disinfect every day during flu season?
CDC's facility guidance centers on regular cleaning, with disinfecting added in high-traffic areas or where people have obviously been ill. Your own policy and local health guidance can set a higher bar.
Is fogging or electrostatic spraying a good way to disinfect an office?
CDC does not recommend fogging, fumigation or electrostatic spraying as primary disinfection methods unless the product label permits them.
This article is for general informational purposes only. Cleaning scope, frequency, and pricing vary by facility size, type, and condition. Service availability depends on your location within Neat & Clean Co's service area. Contact us for a quote specific to your facility.
Related articles

Conference Room Cleaning Schedule: Follow Bookings, Not the Calendar
A fixed weekday slot cleans empty rooms and misses busy ones. Here is how to tie a conference room cleaning schedule to your booking system instead.

Medical Office Cleaning Documentation: Logs and Sign-Off Explained
A cleaning log turns a schedule into a record. See what CDC guidance says a log should capture, who signs off, and how audits keep a medical office on track.

Office Break Room Cleaning Checklist for Facility Managers
The break room is the only room in a commercial building where people prepare food, eat it, and leave it behind — and it is usually the room your cleaning scope describes in a single vague line. This checklist breaks the work down zone by zone, separates the tasks OSHA actually requires from the ones that are quality decisions, and shows facility managers how to assign every line between the janitorial contract and building staff.